MTB Tiger 2 SRS Faster – Stronger – Easier.
Tecno-3 Push Flex – The Tecno-3 Push Flex completely eliminates the pressure zone on the instep and significantly improves the feeling of closure. Equipped with a smaller support surface on the tongue of the shoe, with a central flexing system, it manages to accompany the different needs and conformations of various cyclists, without creating areas of hyper pressure. It guarantees micrometric adjustment, tension closing / release speed and is replaceable.
Reflex Adjustable Heel Retention Device – The Adjustable Heel Retention Device reinforces the top of the heel cup and improves the fit by closing the back of the shoe securely around the rider’s heel. The heel retention device tightens the top of the heel cup so that the heel doesn’t slide out during steep climbs or sprints. Each side of the heel can be adjusted independently, for a perfect fit. For a custom adjustment turn the screw towards the + sign to tighten the heel retention device and towards the – sign to open it. Light weight, easy to use, and replaceable. · For additional security while pedaling, the new adjustable heel device is provided with reflex inserts for more visibility in dark conditions.
Sidi Intergrated Heel Cup – An all new design and light, reinforced to avoid deformation after prolonged efforts and pressures. Anatomically shaped, it stabilizes and supports the foot when pedalling. The reflective inserts on the heel provide greater safety to the athlete on the road, helping to signal the presence of the cyclist in conditions of poor visibility.
Rubber Toe – Upper part of the toe section is rubberised to resist and deflect impacts from stones or debris when cycling. It is made with anti-slip rubber.
MTB SRS Carbon-Ground Sole – The MTB SRS Carbon-Ground Sole raises the standard for mountain bike performance, dropping off about 100 grams per pair compared to the previous Dragon Carbon SRS sole without sacrificing power or durability. The MTB SRS Carbon-Ground Sole consists of replaceable tread blocks in the toe and heel attached to a medium-modulus carbon sole, plus the innovative Replaceable MTB Plate, designed to prevent sole damage from pedal contact. Most Dual-Retention Bar type MTB Pedals (such as Crankbrothers and LOOK) recommend using a reinforcement plate between the cleat and the shoe in order to prevent cracking or denting the sole. The MTB Plate can be replaced in case of damage from the pedal system, so adding the weight of an aftermarket reinforcement plate is optional. The Ground SRS treads and MTB Plate are easily removable and replaceable. The MTB SRS Carbon-Ground Sole is toe-spike compatible.
Maasure your foot by following these steps:
- Put a sheet of paper on the floor with the short side against the wall.
- Put the sole of your bare foot on it with the heel pressing against the wall
- Mark the point in front of the tip of your longest toe on the sheet of paper.
- Measure the distance between the margin of the sheet of paper where you placed your heel and the point where you made the mark. Always round up the measurement to the next millimetre.
You may find that your right and left foot are different lengths. Always measure both of them and use the longest measurement as your reference.
If you are undecided between two sizes after consulting the table, we recommend that you opt for the larger size.